How to refill the stamps
Self inking stamp
Self-inking stamps have an internal ink pad that wets the rubber die with ink
after each use. the ink colour usually is black, blue , red, purple or green, even
more for some brands, fromtime to time, the ink pad can run low or dry out,
To refill the ink pad, press the stamp dowm slightly, usually less than a quarter
of an inch, Push the ink pad out from the back of the stamp to the front with your
index finger. Pull it the remainder of the way out of the front. Keep the ink pad
horizontal. Drip five or six drops directly onto the pad. The procedure for
refilling the stamper will vary slightly depending on the individual stamper model,
but the basic process is the same for most stampers. Leave the pad for a few
minutes, press the stamp down slight, same position as you pushed the pad out,
then push the refilled pad back to the position, make sure the same position
before you pushed out the pad. That’s it!
after each use. the ink colour usually is black, blue , red, purple or green, even
more for some brands, fromtime to time, the ink pad can run low or dry out,
To refill the ink pad, press the stamp dowm slightly, usually less than a quarter
of an inch, Push the ink pad out from the back of the stamp to the front with your
index finger. Pull it the remainder of the way out of the front. Keep the ink pad
horizontal. Drip five or six drops directly onto the pad. The procedure for
refilling the stamper will vary slightly depending on the individual stamper model,
but the basic process is the same for most stampers. Leave the pad for a few
minutes, press the stamp down slight, same position as you pushed the pad out,
then push the refilled pad back to the position, make sure the same position
before you pushed out the pad. That’s it!
Pre-inked stamp
1. With the bottom cover off, push firmly on one of the two ends and slide
out the little “drawer” that holds the stamp die box
2. Drip a few drops of Maxlight Ink (not too much!) into the slots on top.
Carefully reinsert the die box back
3. Set the stamp aside for a couple of hours to
give the ink time to distribute down throughout the cartridge.
out the little “drawer” that holds the stamp die box
2. Drip a few drops of Maxlight Ink (not too much!) into the slots on top.
Carefully reinsert the die box back
3. Set the stamp aside for a couple of hours to
give the ink time to distribute down throughout the cartridge.